Using the optional battery pack
If you use a battery pack such as the
Note
You cannot use the Glasstron with the alkaline batteries. Use the AC power adapter (supplied) or the battery pack (not supplied)
Charging the battery pack
Charge the battery pack before use. You can charge the battery pack using the power supply box. If you attach the battery pack as described below, the battery pack charges while you are not using the Glasstron.
1 | Attach the battery pack to the power supply box. | |
| Install the battery pack properly making |
|
| sure it is not crooked against the power | Battery pack |
| supply box. | Power supply |
| To remove the battery pack, while | box |
| sliding BATT RELEASE, pull out the |
|
| battery pack. | BATT RELEASE |
|
| |
|
| button |
2 | Connect the AC power adapter to the DC IN connector on the | |
| power supply box. Then, connect the mains lead to the AC power | |
adapter and to a mains.
Charge the battery pack on a flat place without vibration.
The CHARGE lamp lights up. When the battery pack is fully charged, the CHARGE lamp goes out.
Battery life and charging time are shown in the table on the next page.
to mains
CHARGE lamp
AC power adapter
to DC IN
Notes
•If the POWER/POWER SAVING lamp flashes while using the battery pack, charge the battery pack.
•If the CHARGE lamp flashes, the power supply box or battery pack is malfunctioning. Contact your Sony dealer or local authorised Sony service facility.
•Use the supplied AC power adapter only when charging a battery pack.
•Battery life may be shorter in a cold environment. This is a typical battery characteristic.
•You cannot charge the battery pack in power save mode. Turn off the Glasstron, then it starts charging the battery pack.
