Setting remote control codes that are not
stored in the commander
When a remote control code is not one of the presets stored in the commander, it is possible for the commander to learn the code using the Learning function. For details on how to use the learned codes, please see page 17.
1Touch SETUP.
The SETUP screen appears.
6Point the remote code receiver section of the commander toward the receiver/transmitter on the remote control to be learned.
About 5 cm ~ 15 cm
7Press the appropriate button on the remote control to send the remote control code.
Lightly pressing the button once should be sufficient. In about 3 to 5 seconds, it is displayed whether learning was successful or not.
When learning is successful, “Learning OK!” is displayed, and a mark (■) will appear next to the selected box.
Operation
2Touch LEARNING.
Learning area
Code set mark
Box number assigned for new code
3Touch the area corresponding to where you want the new code to be learned. Any letter from A to J can be selected (for example, select “A”).
4Touch the Box Number where you want to save the new code (for example, select “A6”).
The LEARNING SETUP screen is displayed.
Box number assigned for new code
Message window
Command button
Name input button
When learning is not successful, “Learning Fail..” is displayed, and 3 seconds later “Please Send Signal” is displayed again. Please do this procedure again from step 6.
To erase the learned code
After step 7, touch “Clear” and the display changes to “Clear?”. If “Yes” is touched at this time, the newly learned code is erased. If “No” is touched, the code is not erased, and the commander returns to its previous condition.
zYou can test the learned code
Touch “TEST” after “Learning OK” is displayed in step 7. The learned code is sent from the commander, and if correct, the operation corresponding to the learned code is performed.
zYou can make a name of up to 14 characters for the learned code
Touch name input buttons as displayed in step 4 to enter the name.
5Touch “Learning Start”.
“Please Send Signal” is displayed.