Adjusting the Commander’s Operating Environment

Operation

Notes

•Normally, in the areas from A to J, there is a total of 80 BOX Numbers that can be used with the Learning function. However, depending on the signals of the codes being learned, it may not be possible for the commander to store codes for all 80 BOX Numbers.

•To learn commands such as volume, fast-forward, rewind (etc.) that are generally performed by continuously pressing the button, press and hold the button until “Learning OK” appears in step 7. For other commands such as play, pause, and stop (etc.) where continuously holding the button is not necessary, learning is usually possible by pressing the button once.

•Some remote control codes cannot be learned.

Other setup

pAdjusting the position of the touch panel (LCD)

Adjust the position of the LCD when it shifts from the normal operating position.

1Touch TOUCH PANEL on the SETUP screen.

The TOUCH PANEL ADJUSTMENT screen appears.

2Touch the center of each of the 4 dots.

(For details, see “Touch panel adjustment” on page 6.) “Adjusted” appears in a short while and long beep is emitted.

pSetting the AUTO POWER function

ON: When a video function (DVD, etc.) is selected, the commander sends numerous codes to the appropriate Sony AV components. At this time, the TV automatically switches to VIDEO 1 input mode.* Example) When you select DVD, the following occurs.

1The receiver/amplifier switches to DVD player operation mode.

2The TV turns on.

3The DVD player turns on.

4The TV automatically selects VIDEO 1 input.

OFF: When a function is selected, the commander code applies only to receiver/amplifier operation.

*Switching to VIDEO 1 input may not be automatic on all Sony TVs. This is because some TVs cannot receive remote control codes immediately after being turned on.

30GB

pChanging the function of the SYSTEM STANDBY button

ALL OFF: Switches power of all Sony AV components off.

ON/OFF: Switches only the receiver/amplifier on or off.

pSetting the operation beep sound on or off

A beep can be set to sound or not sound when the touch panel is touched.

Touch ON (sound) or OFF (no sound) in BEEP:ON OFF in the SETUP screen.

pSetting the warning alarm on or off

A warning alarm can be set to sound or not sound when a communication error has occurred.

Touch ON (sound) or OFF (no sound) in ALARM:ON OFF in the SETUP screen.

pReturning settings to their factory preset settings

Use this function to erase all memorized settings and return them to their factory presets.

Please note that once erased, settings cannot be returned.

When carrying out this operation, make sure that the receiver/ amplifier’s power is on, and be sure to point the commander’s transmitter/receiver section toward the display on the receiver/ amplifier.

1Touch ALL CLEAR on the SETUP screen.

2Touch YES.

pCONTROL A1 auto function (AUTO FUNC)

ON: When a component connected via a CONROL A1 cord is played, the power to this unit is turned on and the function selector is automatically set for that component.

OFF: When you do not want linked control of connected components, select [OFF].

When AUTO FUNC does not appear in the display, use the JOG DIAL to scroll the screen until AUTO FUNC appears.