5. Description of Transport Mode
Mode name | Description | Lit lamp | |
|
|
| (over key) |
|
|
|
|
STOP | This is stopped status. | STOP | |
|
| This is the mode entered when the power for the recording unit is |
|
|
| turned on. Be sure to set to this mode before turning off the power. |
|
|
|
|
|
This mode is for adjusting the range and offset while checking the | REC | ||
|
| signal on the screen before actual recording. |
|
|
|
|
|
REC | This mode is for recording the data to recording media. Monitoring | REC, FWD | |
|
| can also be performed at the same time. |
|
|
|
|
|
This mode pauses REC mode. When the pause is cancelled, the ID | REC, FWD, | ||
|
| is sent, and the next recording data is processed using the next ID | PAUSE |
|
| number. |
|
|
|
|
|
FWD | This plays back the data recorded on the recording media. | FWD | |
|
|
|
|
This mode pauses the FWD mode. When the pause is cancelled, | FWD, | ||
|
| playback starts from the data at that point. | PAUSE |
|
|
|
|
FF | This | FF | |
|
|
|
|
REW | This rewinds data playback. | REW | |
|
|
|
|
ID skip | This searches and plays back the start of the current or next ID block. |
| |
|
|
|
|
SEARCH | This performs a search. The following searches are available. |
| |
|
| (See “16. Search.”) |
|
|
|
|
|
| Start ID search | This searches the ID at the start position for each recording. |
|
|
|
|
|
| ID/INDEX | This sets the ID/INDEX number and searches the start. |
|
| number search |
|
|
|
|
|
|
| Mark search | This searches the Mark1/Mark2 that were marked in the recording |
|
|
| media. |
|
|
|
|
|
| Address search | This searches designated addresses (controlled by Telnet). |
|
|
|
|
|
| This searches the specified |
| |
| search | recording media (controlled by Telnet). |
|
|
|
|
|
| Manual search | This performs |
|
|
|
|
|
(E) |