Caution
Please read carefully the following precautions prior to use. These precautions will prevent your data on recording media from being damaged or lost.
Condensation
In the default settings, the condensation sensor on this unit is set to off.
(1)Always turn the condensation sensor on under conditions where condensation may form easily such as when the temperature around the recording unit goes from a low to high temperature.
(2)To prevent damage to data in environments where condensation tends to occur, be sure to always eject the recording media after using the recording unit, and then press the POWER switch to turn off the power.
<Reference> (Section
Off : Condensation is not detected. If condensation occurs the recording media and data may become damaged.
On : Condensation is detected when the unit’s power is turned on to protect the recording media and data from being damaged.
Warming Up/Cooling Down
When the temperature inside the unit is too high or too low, the unit displays one of the following messages and the unit is automatically cooled down or warming up. The unit cannot be operated until the temperature reaches proper level and the message on LCD display disappears.
LCD message | Recording unit status | Remarks |
Low Temp Warming Up | Internal temperature < 5 dC | Displayed until the internal temperature is |
| 70 dC <Internal temperature | 5 dC or higher |
High Temp Cooling Down | Displayed until the internal temperature is less | |
|
| than 70 dC |
|
|
|
Overwrite
Once overwritten, the previously recorded data after the point where the overwriting ends cannot be reproduced (see section
<Reference> (Section
Overwriting is prohibited in the default settings.
To cancel the overwrite protection, set the Overwrite option under Utility_Global Setup Menu_Function to On in the LCD screen.
In an attempt of overwriting, a message “Overwrite?” will appear on the LCD of the recording unit. If you wish to overwrite the old data, press FWD key with REC key pressed down.
Power Switch
When turning off the unit completely, first confirm that the ACCESS lamp is out and then turn off the POWER switch on the rear of unit.
(E) (3) |