For more information about the shutter speed and mode settings, see Section 4-2 “Setting the Electronic Shutter” (page 4-13).
qk REMOTE (remote control) connector (8-pin) | 2 |
Connect the RM-B150 remote control unit (not supplied) to this |
connector.
Connect the RM-P9 Remote Control Unit (not supplied) with conversion cable or VA-DN1 Camcorder Interface Adaptor (not supplied) to this connector.
By connecting a camcorder interface adaptor, you can control the VTR from a 9-pin remote control device.
Note
If the REMOTE and TEST OUT connectors are used at the same time, it may not be possible to generate video signals at standard levels.
ql VIDEO OUT (video output) connector (BNC type)
This connector outputs a composite signal (standard level, 75-ohm terminated) to the video monitor. If the video monitor is connected here, you can monitor the picture being shot by the camcorder as well as the picture recorded by the VTR. When synchronizing the time code of an external VTR with that of the camcorder, connect this connector to the video input connector of the external VTR.
By attaching the BKDW-702 extension board (not supplied), you can output an SDI signal (corresponding to EDH) from the VIDEO OUT connector. Select composite video signal output or SDI signal output through the setup menu.
See Section 4-9-2 “Selecting the Functions” (page 4-79) for details on selecting the signal output from the VIDEO OUT connector.
w; ASSIGNABLE (assigning function) button
You can assign ATW, RET, REC and other functions to this switch.
See Section 4-9-2 “Selecting the Functions” (page 4-79) for details on the functions that can be assigned and settings.
Chapter 2 Locations and Functions of Parts and Controls 2-23