• The time code stops advancing while time data is being set (when the |
|
| |
recording immediately after switching to |
|
position other than SET), you may overwrite a portion of the |
|
previously recorded time code. |
|
• Recontinuation recording in Loop Rec mode is done in the same way | 3 |
as normal recording. In Loop Rec mode, however, when recording is |
recontinued, the Loop Rec time is subject to a decrease of up to 0.3 second.
Turning off the camera
•When you turn the POWER switch to OFF, the camera will turn off by itself after the tape has run for a few seconds.
•If you remove the battery, pull out the DC cable, or cut the power to the AC adaptor during recording, the image currently being shot on the camcorder will not be recorded. For this reason, take care not to change the battery while recording.
When the tape runs out during recording
Please note that picture data at the instant the tape stopped is not recorded if the tape runs out and the camcorder stops. The recorded picture data is interrupted before the recording stop point.
Chapter 3 Recording and Playback