Rear panel

1 2 3

4

5

1 6

7

3 #

3 #

3 #

3

# 3 #

qf qd

qs qa 0

9 8

AANT IN a/b connectors (BNC type)

Connect antennas for the tuner unit installed in the SRP- X500P. Only the supplied antennas or the UHF Antenna AN-820 (not supplied) can be used.

Notes

•If the antenna is not installed correctly, faulty reception may result, including intermittent sound. The performance of the antenna should be fully confirmed prior to installation, especially if the location does not allow the antenna to be easily repositioned after installation.

•Use a coaxial cable with impedance of 50Ω to connect the antenna. In the case of a 5D-FB cable, the maximum

length is approximately 50 meters. Do not use 5C-2V or other cables with an impedance of 75Ω, as such cables have a short maximum cable length that is about half that of a 5D-FB and may be a source of technical problems.

•Do not install the supplied antennas in a place surrounded by metal object, as this may cause the reception failure.

If noise occurs

Depending on the installation location, it may be impossible to use a specific channel due to external noise or electromagnetic interference. If this happens, with the wireless microphone or the transmitter turned off, select a channel on the tuner unit that does not light up the RF indicator (i.e., a channel that is not adversely affected by noise or interference). Then set the wireless microphone or the transmitter to the same channel as the tuner unit.

BPROJECTOR CONTROL CONTROL S IN/OUT connectors (stereo mini jack)

Used to control the LCD Data Projector VPL-PX15 exclusively.

For details on the function of this connector, see

“PROJECTOR CONTROL CONTROL S IN/OUT connectors” (page 24).

CPROJECTOR CONTROL RS-232C connector (D-

sub, 9-pin, male)

Used for the control of a projector or display monitor with an RS-232C connector connected to the FOUTPUT COMPONENT/RGB or OUTPUT VIDEO connector of the SRP-X500P.

DREMOTE PARALLEL connector (D-sub, 25-pin,

female)

This connector consists of 10 input pins and 10 output pins. The SRP-X500P can be controlled by a switch or volume controller connected to the input pins. Connecting these pins to an emergency broadcast system allows the SRP-X500P’s audio output to be cut off during an emergency broadcast.

An LED can be connected to the output pins to indicate the unit’s status.

The following devices can be connected to this connector.

12 Location and Function of Parts