Installation

Installing the tuner units

Up to two WRU-806 UHF Synthesizer Tuner Units (not supplied) or two URX-M1 Tuner Units included in the UWP-X1/X2 (not supplied) can be installed in the SRP- X500P.

Notes

•To prevent the production of noise, be sure to turn the SRP-X500P off before installing or removing the tuner units.

•When installing the tuner unit, insert it fully into the tuner slot of the SRP-X500P and secure it with the latch on the slot.

•Do not touch the inside of the tuner unit slots.

1 Turn off the SRP-X500P, check the top and bottom sides of the tuner unit, and then insert it into the slot.

Tuner unit

Latch

2 Turn on the SRP-X500P and perform the group and channel settings for the tuner unit, following the instructions in “WRU-806 channel setting” (page 15).

Make the same group and the channel settings for the wireless microphone used in conjunction with the tuner unit.

For details on settings of the UWP-X1/X2, refer to the Operating Instructions supplied with the product.

3 Turn on the wireless microphone and check that the tuner unit is receiving a signal from the microphone.

While a signal is being properly received from the microphone, the RF indicator on the tuner unit lights up.

If the RF indicator does not light up, this means the channel setting for the microphone is different from

that of the tuner unit, or that the battery in the microphone is running down.

To remove the tuner unit

Pull the latch securing the tuner unit to the side and pull out the tuner unit.

Tuner unit

Latch

About blank panels

Two blank panels (large and small) are attached to the front of the SRP-X500P.

Remove both of these panels to perform settings. After completing the settings, reattach the panels to prevent malfunctioning of the unit and to keep the tuner units from falling off the slot.

When the input level controls are used

Blank panel (large)

When the input level controls are not used

Blank panel (large)

Blank panel (small)

14 Installation