BACK REDUCER button to cancel the procedure, turn down the SPEAKER OUT control, then try again.

•Do not make a noise while the SRP-X500P is scanning the frequency bands, as this may cause error in detection.

•When you use the AGC (automatic gain control) function, do the setting by using the SRP-X500P Manager software before performing the procedure above.

Controls

This section explains how to use the control connectors on the SRP-X500P and how to program an optional programmable remote commander with the functions of the SRP-X500P.

PROJECTOR CONTROL RS-232C connector

The PROJECTOR CONTROL RS-232C connector can be used to control a projector or display monitor equipped with an RS-232C connector.

When the SRP-X500P is connected to a projector or monitor through the PROJECTOR CONTROL RS-232C connector, the power status (on or standby) and input signal selection of the projector or monitor are linked to those of the SRP-X500P.

Set the PROJECTOR PROTOCOL selector in accordance with the model of the projector or monitor, as indicated in the following table.

The format of the video signal output to the COMPONENT/RGB connector is factory-set to RGB format. To change the setting, refer to the SRP-X500P Manager User’s Guide.

Product model

PROJECTOR

RGB input

 

PROTOCOL

connector on the

 

selector setting

projector or

 

 

monitor

 

 

 

VPL-CX85/80

1

INPUT A

 

 

 

VPL-PX35/40

2

INPUT D

 

 

 

VPL-FX51/50

3

INPUT A

 

 

 

VPL-PX11

4

INPUT A

 

 

 

VPL-PX32/31

5

INPUT A

 

 

 

FWD-50PX1

6

INPUT 1

 

 

 

PFM-42X1/V1

7

INPUT 1

 

 

 

PFM-42B2/B1

8

INPUT 1

 

 

 

PFM-50C1

9

INPUT A

 

 

 

Not applicable

B-F

-

 

 

 

Notes

•Use the cable whose specifications are matched with the projector or monitor to connect the PROJECTOR CONTROL RS-232C connector on the SRP-X500P with the RS-232C connector on the projector or monitor.

•When controlling the projector from the SRP-X500P, be sure to turn off the Smart APA function and Auto Input Search function on the projector.

•If the projector or a display monitor is not included in the table above, set the PROJECTOR PROTOCOL selector

Controls 23