Sony SRP-X500P manual 18

Sample system configuration with a custom operation panel and environmental equipment connected

In this configuration, the SRP-X500P can be controlled by a custom operation panel or an external system controller.

AN-820 UHF Antenna or the

supplied antenna

Transmitter

Wireless microphone

Document camera

VIDEO OUT

Table-top	VIDEO OUT	LINE OUT
microphone, etc.

VCR , DVD player, etc.

RGB OUT

Programmable

remotePC commander

LINE OUT

		Projector
PROJECTOR CONTROL RS-232C
	INPUT
	AN-820 UHF
	Antenna or the
	supplied
Custom operation panel	antenna	Front
Operation		speaker
		(L)
terminal
	Wireless	Transmitter
External system controller	microphone

3 #

3 #

3#

3

	#	3 #	Front
			speaker
			(R)
			To power
			source
LINE OUT	LINE	I/F
	IN
		BOX
MD recorder			Screen
		I/F	Rear
RGB OUT		BOX
			speaker (L)
PC			Curtain
	LINE
		I/F	Rear
	OUT
		BOX	speaker (R)
			Lighting
			equipment

•The SRP-X500P and the connected devices can be controlled by commands sent by an external system controller to the SRP-X500P. (System controller software is required.)

•The configuration above uses two WRU-806 UHF Synthesizer Tuner Units or two URX-M1 Tuner Units included in the UWP-X1/X2.

•When an electret condenser microphone is connected to the MIC INPUT 3 or 4 connector, set the +48V ON/OFF switch for the applicable connector to ON.

•When controlling the environment equipment such as screen, curtains, and lighting equipment through the REMOTE PARALLEL connector, interface boxes are required.

For details on the use of a custom operation panel and interface boxes, see “REMOTE PARALLEL connector” (page 24).

18 System Configurations and Speaker Connections