Performing initial setup operations

Before using the receiver for the first time, initialize the receiver by performing the following procedure. This procedure can also be used to return settings you have made to their factory defaults.

Be sure to use the buttons on the receiver for this operation.

1,2

?/1

 

 

 

 

 

 

 

 

MASTER VOLUME

 

 

 

MULTI CHANNEL DECODING

 

 

 

 

 

TONE MODE

TUNING MODE

 

 

 

 

 

DISPLAY

INPUT MODE

 

TONE

TUNING

 

 

 

 

 

INPUT SELECTOR

 

SPEAKERS

 

 

 

 

 

 

 

 

 

(OFF/A/B/A+B)

 

 

 

 

 

 

 

 

 

AUTO CAL MIC

 

 

 

 

 

 

 

 

 

 

MEMORY/

 

SUR BACK

 

 

 

 

 

 

 

ENTER

DIMMER

SLEEP DECODING

2CH

A.F.D.

MOVIE

MUSIC

AUTO CAL

DIRECT

VIDEO 3 IN/PORTABLE AV IN

 

 

 

 

 

 

 

 

PHONES

 

 

 

 

 

 

 

 

 

VIDEO

L AUDIO R

 

 

 

 

 

 

 

 

3

1 Press ?/1 to turn off the receiver.

2 Hold down ?/1 for 5 seconds.

“PUSH” and “ENTER” appears on the display alternately.

3 Press MEMORY/ENTER.

After “CLEARING” appears on the display for a while, “CLEARED” appears.

The following items are reset to their factory settings.

•All settings in the LEVEL, EQ, SUR,

TUNER, AUDIO, VIDEO, SYSTEM and A. CAL menus.

•The sound field memorized for each input and preset station.

•All sound field parameters.

•All preset stations.

•All index names for inputs and preset stations.

•MASTER VOLUME is set to “VOL MIN”.

•Input is set to “DVD”.

Inserting batteries into the remote

Insert two R6 (size-AA) batteries in the RM-AAP017 remote commander.

Observe the correct polarity when installing batteries.

Notes

•Do not leave the remote in an extremely hot or humid place.

•Do not use a new battery with old ones.

•Do not mix alkaline batteries and other kinds of batteries.

•Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction.

•If you do not intend to use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.

•When you replace the batteries, the programmed remote codes may be cleared. If this happens, program the remote codes again (page 78).

Tip

Under normal conditions, the batteries should last for about 3 months. When the remote no longer operates the receiver, replace all the batteries with new ones.

32GB