Confirming/saving the measurement results

1 Confirm the measurement result.

When the measurement ends, a beep sounds and the measurement result appears on the display.

Measurement Display

Explanation

result

 

 

 

 

 

When the

SAVE

Proceed to step

measurement

 

2.

process

 

 

completes

 

 

properly

 

 

 

 

 

When the

ERROR

See “When

measurement

XXXX

error codes

process fails

 

appear” (page

 

 

36).

2 Press RECEIVER and then press V/v repeatedly to select the item. Then, press .

Item

Explanation

RETRY

Performs the Auto

 

Calibration again.

 

 

SAVE

Saves the measurement

 

results and exits the setting

 

process.

 

 

WARN CHK

Displays warning

 

concerning the

 

measurement results. See

 

“When you select “WARN

 

CHK”” (page 37).

 

 

PHASE

Displays the phase of each

 

speaker (in phase/out of

 

phase). See “When you

 

select “PHASE”” (page 37).

 

 

DISTANCE

Displays the measurement

 

result for speaker distance.

 

 

LEVEL

Displays the measurement

 

result for speaker level.

 

 

EXIT

Exits the setting process

 

without saving the

 

measurement results.

 

 

3 Save the measurement result.

Select “SAVE” in step 2.

The measurement results are saved and you can select the calibration type in the A. CAL menu.

For details on calibration type, see page 38.

Tip

The size of a speaker (LARGE/SMALL) is determined by the low frequency characteristics. The measurement results may vary, depending on the position of the optimizer microphone and speakers, and the shape of the room. It is recommended that you follow the measurement results. However, you can change those settings in the SYSTEM menu (page 47). Save the measurement results first, then try to change the settings if you want.

When error codes appear

Try the remedies and perform the Auto Calibration again.

Error code

Cause and remedies

ERROR 31 The SPEAKERS (OFF/A/B/ A+B) is set to off. Set it to others and perform the Auto Calibration again.

ERROR 32 None of the speakers were detected. Make sure that the optimizer microphone is connected properly and perform the Auto Calibration again.

If the optimizer microphone is connected properly but the error code appears, the optimizer microphone cable may be damaged or improperly connected.

ERROR F 33 • None of the front speakers are connected or only one front speaker is connected.

•The optimizer microphone is not connected.

36GB