andConnections Preparations

Adjusting the picture position using the

 

 

supplied adjuster spacer

 

Attaching one of the supplied spacers for adjuster

 

adjustment (spacers for 1º and 2°) allows you to tilt

 

the projector to the right or left at a tilting angle up to

 

2º.

 

 

Adjuster

Adjuster

spacer

spacer

(supplied)

(supplied)

To attach the supplied adjuster spacer

1Place a thick cloth (e.g., a cushion) beneath the projector. Place the projector face down.

2While pressing the lock knobs inward, remove the adjuster bar at the bottom of the adjuster table to which you want to attach the supplied spacer.

3Fit the spacer into the removed adjuster bar spot.

When projecting using both “Side Shot” and “V Keystone” adjustments

1Use the adjuster to adjust the vertical position.

If you set “V Keystone” in the INSTALL SETTING menu to “Auto” (1 page 27), the vertical distortion will be automatically corrected.

Note

The “V Keystone” adjustment may not correct trapezoidal distortion perfectly, depending on the room temperature or the screen angle. In this case, adjust the distortion manually.

2Adjust so that the left or right side of the picture fits that of the screen.

If you position the projector on the left side of the screen, adjust so that the left side of the picture fits the left side of the screen. With the projector positioned on the right side, adjust so that the right side fits the right side of the screen.

At the same time, align the bottom side of the picture with that of the screen.

Screen

Picture

3Adjust to correct horizontal trapezoidal distortion using the SIDE SHOT + or – button.

Press SIDE SHOT + or – so that the upper side of the picture becomes parallel to the bottom side. If the left side is longer than the right side, press SIDE SHOT –.

SIDE SHOT

Press SIDE SHOT + if the right side is longer. To fine- adjust the distortion, press M or m.

GB 14

Step 3: Adjusting the Picture Size and Position