Do not use the projector under the following

2 Insert the Cinema Filter, aligning its screw

conditions:

with the thread around the projector’s

 

lens, then turn the Filter clockwise.

Tilting the unit extremely

 

Cinema Filter

and Connections Preparations

Blocking the ventilation holes

Ventilation Ventilation

holesholes

(exhaust)(intake)

Placing the projector without the adjuster

Note

Installing the unit at altitudes

When using the projector at an altitude of 1,500 m or higher, turn on high altitude mode in the INSTALL SETTING menu. Failing to set this mode when using the projector at high altitudes could have adverse effects, such as reducing the reliability of certain components.

Using the supplied Cinema Filter

The Cinema Filter is supplied with the projector, allowing you to receive higher contrast color and emphasized black color by attaching or removing. Use it according to preference.

To attach the Cinema Filter

1Turn off the power and disconnect the power cord.

To remove the Cinema Filter, turn it counterclockwise.

Using the Optional

Conversion Lens

You can install the optional VPLL-CW20 Short Focused Conversion Lens on the projector. For projection distances when installing the Conversion Lens, see page 36.

Follow the steps below to install the Conversion Lens. For details on installing the Lens, refer also to the installation manual supplied with the Lens.

1Turn off the power and disconnect the power cord.

2Remove the lens cap from the Conversion Lens.

3Align the screw of the Conversion Lens with the thread around the lens of the projector as illustrated below.

Step 1: Installing the Projector

7 GB