Others

6While pushing the projector cover toward you by holding both sides of the cover on the lens side, close the cover until it clicks.

2

1

7Connect the power cord and set the projector to standby mode.

8Press the following buttons on the remote control in the following order for less than five seconds each: RESET, <, ,, ENTER.

Notes

•Do not put your hands into the lamp replacement spot, and do not allow any liquid or object to fall into it to avoid electrical shock or fire.

•Be sure to use the LMP-H150 Projector Lamp for replacement. If you use lamps other than LMP-H150, a malfunction may occur.

•Be sure to turn off the projector and unplug the power cord before replacing the lamp.

Disposal of used projector lamp

As the materials used in this lamp are similar to those of a fluorescent lamp, you should dispose of a used projector lamp in the same way as a fluorescent lamp.

Replacing the Air Filter

The air filter should be replaced periodically. When “Please replace the filter.” appears on the screen, replace the air filter immediately.

Notes

•Replacing the air filter is very important to maintain the high efficiency of the projector and to prevent a malfunction. When the replacement message appears on the screen, replace the air filter without delay.

•When removing the air filter from the projector, be careful that no dust or object gets into the inside of the projector.

•Before replacing the air filter, turn off the projector and unplug the power cord.

1Hold down the adjuster lock lever, slide it to the right, raise the rear of the projector, then return the adjuster lock lever. While keeping the screw on the bottom of the projector turned inward with a coin or a slotted screwdriver, open the projector cover with your hand.

Note

Be sure that the projector is stable.

2Push the filter lock knob to remove the filter cover.

3Remove the air filter from the filter holder by holding the tab on the air filter.

Air filter

Filter holder

GB 32 Replacing the Air Filter