Control Panel

 

 

LAMP/

TEMP/

POWER ON/

q;

 

 

COVER

FAN

SAVING STANDBY

 

 

 

HELP

 

MENU

9

 

 

 

 

 

VOLUME

APA

RESET

INPUT

 

 

ENTER

 

12 3 4 5 6 7 8

1HELP key

If you need help information during an operation, press this key to display help messages. The Help menu lists error recovery techniques depending on problem type.

2VOLUME +/– keys

Adjust the volume of the built-in speakers.

+: Increases the volume.

– :Decreases the volume.

3APA (Auto Pixel Alignment) key

Adjusts the picture to be projected automatically to give the clearest picture possible while a signal from the computer is input. Adjusts the shift (up/down and left/right) at the same time automatically.

Note

Press the APA key when the full image is displayed on the screen. If there are black edges around the image, the APA function will not function properly and the image may extend beyond the screen.

4RESET key

Resets the value of an item to its factory preset value. This key functions when the menu or a setting item is displayed on the screen.

5Arrow (M/m/</,) keys

Used to select a menu or to make various adjustments.

6ENTER key

Enters the settings of items in the menu system.

Location and Function of Controls

7INPUT key

Selects the input signal. Each time you press the key, the input signal switches as follows:

INPUT-A INPUT-B

S-VIDEO VIDEO

Note

The audio signals are the same for the VIDEO and S-VIDEO.

8I / 1 (on / standby) key

Turns the projector on and off when the projector is in the standby mode. The ON/STANDBY indicator lights in green when the power is turned on.

When turning off the power, press the I / 1 key twice following the message on the screen, or press and hold the key for about one second.

For details on steps for turning off the power, see “To turn off the power” on page 20 (GB).

9MENU key

Displays the on-screen menu. Press again to clear the menu.

0Indicators

LAMP/COVER: Lights up or flashes under the following conditions:

•Lights up when the lamp has reached the end of its life or has reached a high temperature.

•Flashes when the lamp cover or air filter cover is not secured firmly.

TEMP (Temperature)/FAN: Lights up or flashes under the following conditions:

•Lights up when temperature inside the projector becomes unusually high.

•Flashes when the fan is broken.

POWER SAVING: Lights up when the projector is in the power saving mode. When POWER SAVING in the SET SETTING menu is set to ON, the projector goes into the power saving mode if no signal is input for 10 minutes. Although the lamp goes out, the cooling fan keeps running. The power saving mode is canceled when a signal is input or any key is pressed. However, in the power saving mode, none of the keys function for the first 60 seconds.

11 (GB)