Using the Menu

Using the Menu

The projector is equipped with an on-screen menu for making various adjustments and settings.

To select the language used in the menu, see page 18 (GB).

1 Press the MENU key.

The menu display appears.

The menu presently selected is shown as a yellow button.

PICTURE CTRL

INPUT-A

 

CONTRAST: 80

BRIGHT: 50

RGB ENHANCER: 30

GAMMA MODE: GRAPHICS

COLOR TEMP: LOW

VOLUME: 50

2 Use the M or m key to select a menu, then press the , or ENTER key.

The selected menu appears.

Menus

Setting items

SET SETTING

INPUT-A

 

 

STATUS:

ON

 

INPUT-A:

COMPUTER

 

AUTO INPUT SEL: OFF

 

LANGUAGE: ENGLISH

 

SPEAKER:

ON

 

POWER SAVING:

OFF

 

IR RECEIVER:

FRONT&REAR

3 Select an item.

Use the M or m key to select the item, then press the , or ENTER key.

4 Make settings or adjustments on an item.

For details on setting individual items, see the relevant menu pages.

To clear the menu

Press the MENU key.

The menu display disappears automatically if no key is pressed for one minute.

To reset items that have been adjusted

Press the RESET key.

“Complete!” appears on the screen and the settings appearing on the screen will be reset to their factory preset values.

Items that can be reset are:

•“CONTRAST, ” “BRIGHT, ” “COLOR, ” “HUE,” “SHARP,” and “RGB ENHANCER” in the PICTURE CTRL menu.

•“DOT PHASE, ” “SIZE H,” and “SHIFT” in the INPUT SETTING menu.

•“DIGIT KEYSTONE” in the INSTALL SETTING menu.

About the retention of the settings

The settings are automatically stored in the projector memory.

When no signal is input

When there is no input signal, “NO INPUT–Cannot adjust this item.” appears on the screen, and the items mentioned above cannot be adjusted.

About the menu display

You can set the display position of the menu, the intensity of the background picture, and the color of the menu items as you like.

For details, see page 28 (GB).

22 (GB)