Location and Function of Controls

8FUNCTION 1, 2 keys

Functions when the supplied application software is used. When you connect the projector with a computer, you can open a file on the screen by just pressing a FUNCTION key. This will enhance your presentation. To use this function, allocate a file to the FUNCTION key by using the application software.

For details, see the README file and HELP file supplied with the application software.

9RESET key

Resets the value of an item to its factory preset value or returns the enlarged image back to its original size.

q; D ZOOM +/– key

Enlarges the image at a desired location on the screen. This key works only when a signal from a computer is input.

+: Pressing the + key once displays the icon. This icon indicates the point you want to enlarge. Use an arrow key (M/m/</,) to move the icon to the point to be enlarged. Press the + key repeatedly until the image is enlarged to meet your requirements.

–:Each press of the – key reduces an image that has been enlarged with the D ZOOM + key.

qa L (left) CLICK key

Functions as the left button of a mouse.

qs MENU key

qd D KEYSTONE key

Corrects the trapezoidal distortion caused by the projection angle. Use the arrow keys (M/m/</,) to display the image as a rectangle.

qf INPUT key

qg FREEZE key

Used to freeze the picture projected. To cancel the frozen picture, press the key again.

qh MS SLIDE key

This key does not operate with this unit.

Battery installation

1 Push and slide to open the lid, then install the two R6 (size AA) batteries (supplied) with the correct polarity.

Slide while pressing down on the lid.

Be sure to install the battery from the # side.

2 Replace the lid.

Notes on batteries

•Make sure that the battery orientation is correct when inserting batteries.

•Do not mix an old battery with a new one, or different types of batteries.

•If you do not intend to use the Remote Commander for a long time, remove the batteries to avoid damage from battery leakage. If batteries have leaked, remove them, wipe the battery compartment dry and replace the batteries with new ones.

Notes on Remote Commander operation

•Make sure that there is nothing to obstruct the infrared beam between the Remote Commander and the remote control detector on the projector. Direct the Remote Commander toward the front or rear remote control detector.

•The operation range is limited. The shorter the distance between the Remote Commander and the projector is, the wider the angle within which the commander can control the projector.

14 (GB)