Projecting

To get the clearest picture

You can get the best picture automatically when a signal from the computer is input. Press the APA key. The picture is automatically adjusted to project the clearest picture possible.

Notes

•Adjust the signal when a still picture is displayed on the screen.

•Press the APA key when the full image is displayed on the screen. If there are black edges around the image, the APA function will not function properly and the image may extend beyond the screen.

•If you switch the input signal or re-connect a computer, press the APA key again to get the suitable picture.

•“ADJUSTING” appears on the screen. To restore the original screen, press the APA key again during the adjustment.

•“Complete!” appears on the screen when the picture is adjusted properly. However, depending on the kinds of input signal, the picture may not always be adjusted properly.

•Adjust the items in the INPUT SETTING menu when you adjust the picture manually.

For details on the INPUT SETTING menu, see page 24 (GB).

To correct trapezoidal distortion

When the projected image is a trapezoid, correct it by pressing the D KEYSTONE key on the Remote Commander or by adjusting DIGIT KEYSTONE in the INSTALL SETTING menu.

When the base edge is longer than the upper edge as shown in the figure below:

Set the value to negative.

When the upper edge is longer than the base edge as shown in the figure below:

Set the value to positive.

For details on “DIGIT KEYSTONE,” see page 28 (GB).

To turn off the power

1 Press the I / 1 key.

“Power OFF?” appears on the screen.

Note

The message will disappear if you press any key except the I / 1 key, or if you do not press any key for five seconds.

2 Press the I / 1 key again.

The ON/STANDBY indicator flashes in green and the fan continues to run for about 90 seconds to reduce internal heat build-up. Also, the ON/ STANDBY indicator flashes quickly for the first 60 seconds. During this first 60 seconds, you will not be able to turn the power back on with the

I / 1 key.

3 Unplug the AC power cord from the wall outlet after the ON/STANDBY indicator lights in red.

Note

The built-in circuits provided for carrying out the Off & Go function (page 8 (GB)) may keep the cooling fan running for a while after the ON/ STANDBY indicator turns from green to red just after you turn off the projector by pressing the

I / 1 key.

When you cannot confirm the on-screen message

When you cannot confirm the on-screen message at anytime, you can turn off the power by holding the I / 1 key for about one second.

When you want to turn off the projector quickly

You can also disconnect the power cord without pressing I / 1 key. The cooling fan keeps running automatically due to built-in circuits for a certain period of time even though you unplug the power cord (Off & Go function).

However, if the projector has not been turned on for a long enough time, the cooling fan may not turn since the projector’s condenser has not sufficiently charged.

If you do not use the Off & Go function

Unplug the AC power cord according to the procedure described in “To turn off the power.”

20 (GB)