Southbend sb1015f specifications Adding Cutting Fluid, Power Connection

For Machines Mfg. Since 7/09 P R E P A R A T I O N EVS Toolroom Lathes

In addition to the gearboxes, we also recommend that you lubricate all other points on the machine at this time. This can be accomplished by following the maintenance schedule on Page 54.

Note: If your lathe was shipped with oil in the gearboxes, do not change that oil until after the break-in period.

Adding Cutting Fluid

Add the cutting fluid of your choice now. For detailed instructions on where the cutting fluid tank is located and how to add fluid, refer to Cutting Fluid System on Page 62.

This machine is equipped with a frequency drive that contains sensitive electronics, which can be damaged by a phase converter. DO NOT use a phase converter to power this machine. Doing so will void the warranty.

SB1012 (220V 3-Phase)

Full Load Amp Draw	15.7 Amps
Phase	3-Phase
Frequency	60 Hz
Minimum Circuit Size	20 Amps
Recommended Plug/Receptacle ......NEMA L15-20
Minimum Cord Size	12 AWG, 4-Wire, 300V
Maximum Cord Length	50 ft.

Power Connection

Electrocution or fire may occur if machine is ungrounded, incorrectly connected to power, or connected to an undersized circuit. Use a qualified electrician to ensure a safe power connection.

Once all preparation steps previously described in this manual have been completed, the machine can be connected to the power source. In order to be connected to the power source, a circuit must be installed/prepared that meets the requirements of the lathe, and a power connection method must be established for that circuit. The following lists show the minimum requirements for each model, and instructions follow for each connection method.

Note About Power Cords: Using an incorrectly sized cord causes electrical components on

the machine and the cord to become very hot, which will greatly decrease the life of electrical components or result in fire. For best results, use the shortest length of cord possible for your machine, and never use a smaller cord gauge than the specified minimum.

SB1014, SB1037 (220V 3-Phase)

Full Load Amp Draw	21.7 Amps
Phase	3-Phase
Frequency	60 Hz
Minimum Circuit Size	30 Amps
Recommended Plug/Receptacle ......NEMA L15-30
Minimum Cord Size	8 AWG, 4-Wire, 300V
Maximum Cord Length	50 ft.

SB1013 (440V 3-Phase)

Full Load Amp Draw	7.75 Amps
Phase	3-Phase
Frequency	60 Hz
Minimum Circuit Size	15 Amps
Recommended Power Connection	Hardwire*

SB1015, SB1038 (440V 3-Phase)

Full Load Amp Draw	10.75 Amps
Phase	3-Phase
Frequency	60 Hz
Minimum Circuit Size	15 Amps
Recommended Power Connection	Hardwire*

*Hardwire setups must include a locking disconnect switch between the power source and the lathe. Refer to Page 16 for more details.

-15-