For Machines Mfg. Since 7/09 | S E R V I C E | EVS Toolroom Lathes |
Leadscrew Shear Pin
Replacement | |
| 9mm |
| 7mm |
5.8mm | 3mm |
| 0.5mm |
0.2mm | 0.2mm |
NOTE: Shear Pin Material = S45C (SAE 1045) | |
Figure 142. Shear pin specifications.
Tools Needed: | Qty |
Phillips Screwdriver #2 | 1 |
External Retaining Ring Pliers #1 | 1 |
Magnet | 1 |
Safety Glasses | 1 |
To replace the shear pin:
1.DISCONNECT LATHE FROM POWER!
2.Remove the front and side feed access covers, as shown in Figure 143.
Feed Access Cover
Figure 143. Feed access covers removed.
3.Rotate the shroud washer so the cutout lines up with the shear pin head, as shown in Figure 144.
Shear Pin | Shroud Washer |
Head |
|
Cutout
Figure 144. Shroud washer/pin alignment.
4.Put on safety glasses.
5.Remove the retaining ring from its groove and place it in the
6.Move the shroud washer away from the shear pin (to the rear position), as shown in Figure 145, so there is enough of a gap to remove the shear pin.
Rear
Position
Gap
