EVS Toolroom Lathes | S E R V I C E | For Machines Mfg. Since 7/09 |
5. Remove pedal stop shown in Figure 139. |
|
6. Move the brake band to the right one hole, | Pedal Stop |
and | |
until it is just snug. |
|
— If installing a new brake band, install the |
|
cap screw so there is one hole to the left |
|
for future brake adjustment. |
|
Cap Screw | Pedal Lever |
Move Brake Band to the |
|
Right to Adjust Brake |
|
| Move Pedal Stop Left or Right to |
| Adjust Foot Pedal Height. |
Figure 139. Brake linkage adjustments.
Pedal
Lever
25mm
Pedal Stop
Figure 140. Pedal travel adjustment.
7.Firmly push the pedal lever (Figure 140) to the right until it stops and the brake band is fully clamped around the brake hub.
8.Tap the pedal stop into position so there is approximately a 25mm gap between the pedal lever and the stop (see Figure 140).
9.Tighten the cap screw on the pedal stop.
10.Locate the motor kill switch (shown in Figure 141) at the tailstock end of the lathe.
Plunger | Motor Kill |
and | |
Cam Lobe | Switch |
Figure 141. Motor kill switch.
11.Push the pedal lever down to verify that the cam lobe pushes the kill switch plunger in. When pushed in, the switch should click.
—If the switch does not click, loosen the switch mounting screws, push the pedal all the way down, and move the switch closer to the lobe until it clicks. Secure the switch in place at this location.
—In the released position, there should be an approximate 3mm gap between the plunger roller and the lobe.
12.
