SOYO SY-7VCA Select STANDARD CMOS SETUP, Select LOAD SETUP DEFAULT, Select SOYO COMBO SETUP

Hardware Installation SY-7VCA

Step 1. Select [STANDARD CMOS SETUP]

Set [Date/Time] and [Floppy drive type], then set [Hard Disk Type] to “Auto”.

Step 2. Select [LOAD SETUP DEFAULT]

Select the “LOAD SETUP DEFAULT” menu and type “Y” at the prompt to load the BIOS optimal setup.

Step 3. Select [SOYO COMBO SETUP]

Move the cursor to the [CPU Frequency] field to set the CPU frequency.

Available [CPU Frequency] settings on your SY-7VCA Motherboard are detailed in the following table.

If you set this field to [Manual], you are then required to fill in the next two consecutive fields: (1) the CPU Host/PCI Clock, and (2) the CPU Ratio.

CPU Frequency (MHz)		500MHz (100 x 5.0)	533MHz (133 x 4.0)
	Manual	550MHz (100 x 5.5)	600MHz (133 x 4.5)
	400MHz (66 x 6.0)	600MHz (100 x 6.0)	666MHz (133 x 5.0)
	433MHz (66 x 6.5)	650MHz (100 x 6.5)	733MHz (133 x 5.5)
	466MHz ( 66 x 7.0)	700MHz(100 x 7.0)	800MHz (133 x 6.0)
	500MHz( 66 x 7.5)	750MHz (100 x 7.5)	866MHz (133 x 6.5)
	533MHz ( 66 x 8.0)	800MHz (100 x 8.0)	933MHz (133 x 7.0)
	366MHz (66 x 5.5)	450MHz (100 x 4.5)

Select the working frequency of your Pentium® III, Celeron™ processor among these preset values.

Note: Mark the checkbox that corresponds to the working frequency of your Pentium® III, Celeron™ processor in case the CMOS configuration should be lost.

Step 4. Select [SAVE & EXIT SETUP]

Press <Enter> to save the new configuration to the CMOS memory, and

continue the boot sequence.

45