Projector features / Powereparationson/off

Power on/off

Turning on the power

1. Make sure that the power cord is firmly and correctly connected to the projector and the outlet.

2. Remove the lens cover, and set the power switch to the ON position (marked “ I ”).

The POWER indicator will light up in steady orange (71). Then wait several seconds because the buttons may not function for these several seconds.

3. Press the STANDBY/ON button on the projector or the remote control.

STANDBY/ON button

POWER indicator

 

LASER

 

INDICATOR

STANDBY/ON

VIDEO

RGB

 

 

SEARCH

BLANK

 

LASER

ASPECT

 

 

ENTER

 

 

PAGE UP

 

PAGE DOWN

ESC

MENU

RESET

POSITION

AUTO

 

MAGNIFY

MY BUTTON

VOLUME

ON

1

+

OFF

2

-

FREEZE

KEYSTONE

MUTE

Power switch

The projection lamp will light up and the POWER indicator will begin blinking in green. When the power is completely on, the indicator will stop blinking and light in steady green.

To display the picture, select an input signal according to the section "Selecting an input signal" (18,19).

Turning off the power

1. Press the STANDBY/ON button on the projector or the remote control. The message "Power off?" will appear on the screen for about 5 seconds.

2. Press the STANDBY/ON button on the projector or the remote control again while the message appears.

The projector lamp will go off, and the POWER indicator will begin blinking in orange. Then the POWER indicator will stop blinking and light in steady orange when the lamp cooling is complete.

3. Make sure that the POWER indicator lights in steady orange, and set the power switch to the OFF position (marked “O”).

The POWER indicator will go off. Attach the lens cover.

Do not turn the projector on for 10 minutes or more after turning it off. Turning the projector on again too soon could shorten the lifetime of some consumable parts of the projector.

WARNING ►A strong light is emitted when the projector’s power is on. Do not look into the lens of the projector or look inside of the projector through any of the projector’s openings.

►Do not touch around the lamp cover and the exhaust vents during use or just after use, since it is too hot.

NOTE • Turn the power on/off in right order. Please power on the projector prior to the connected devices. Power off the projector later than the connected devices.

•When the AUTO ON of the OPTION menu is set to the TURN ON, and the power

was turned off by the power switch last time, turning the power switch on makes the projection lamp light on without pushing the STANDBY/ON button (44).

•Use the shutdown switch (73) only when the projector is not turned off by normal procedure.

17