SRS Labs CP-X809 IMAGE menu, From the IMAGE menu, items shown in the table below can be performed

IMAGE menu

IMAGE menu

From the IMAGE menu, items shown in the table below can be performed.

Select an item using the ▲/▼ cursor buttons on the projector or remote control, and press the ► cursor button on the projector or remote control, or ENTER button on the remote control to execute the item. Then perform it according to the following table.

Item Description

Using the ▲/▼ buttons switches the mode for aspect ratio.

For an RGB or MIU signal

NORMAL  4:3  16:9  SMALL

	For an HDMI signal
ASPECT	NORMAL  4:3  16:9  14:9  SMALL
	For a Video signal, S-video signal or Component video signal
	4:3  16:9  14:9  SMALL
	For no signal
	4:3 (fixed)
	• The NORMAL mode keeps the original aspect ratio of the signal.
	Using the ▲/▼ buttons adjusts the over-scan ratio.
OVER SCAN	Large (It reduces picture)  Small (It magnifies picture)
	• This item can be selected only for a video, s-video, component and HDMI signal.
	• When this adjustment is too large, certain degradation may appear
	at the frame area of the picture. In such a case, please adjust small.

Using the ▲/▼ buttons adjusts the vertical position.

Up  Down

•Over-adjusting the vertical position may cause noise to appear on the screen. If this occurs, please reset the vertical position to the default setting. Pressing the RESET

V POSITION button when the V POSITION is selected will reset the V POSITION to the default setting.

• When this function is performed on a video signal, s-video signal, or component video

signal of 480i@60 or 576i@50 input the range of this adjustment depends on the OVER SCAN (above) setting. It is not possible to adjust when the OVER SCAN is set to 10.

• This item cannot be selected for an HDMI signal.

Using the ▲/▼ buttons adjusts the horizontal position.

Left  Right

•Over-adjusting the horizontal position may cause noise to appear on the screen. If this occurs, please reset the horizontal position to the default setting. Pressing the RESET

H POSITION button when the H POSITION is selected will reset the H POSITION to the default setting.

• When this function is performed on a video signal, s-video signal, or component video

signal of 480i@60 or 576i@50 input the range of this adjustment depends on the OVER SCAN (above) setting. It is not possible to adjust when the OVER SCAN is set to 10.

•This item cannot be selected for an HDMI signal. (continued on next page)

30