![](/images/new-backgrounds/1247215/247215259x1.webp)
19.0.2 Cartridges
To check the
Internal Data Base Test
To test the WorldWideBackground.
C-CARD Test
To test the
1.if there is a
2.if there is a
3.if there is not any
4.if there is a User
Indicates if there is a malfunction in the connector.
19.0.3 Serial Ports
If you are having problems receiving data from the
Change Parameters
To change the parameters of the serial interface. This menu allows to select the Port (Signal Source) between PORT 1, PORT 2, PORT 3 (PORT4 and PORT 5 ONLY FOR CPF300I); the Baud Rate between 300, 1200, 2400, 4800, 9600, 38400, 115200; the Data Bits (Word Length) between 7 or 8, the Parity between even, odd or none, the Stop Bits between 1 or 2. Default settings are: Port = PORT 2, Baud Rate = 4800, Data Bits = 8, Parity = none, Stop Bits = 1.
Input Data Display
To allow the GPS Chart Plotter to act as a computer terminal and display the incoming data exactly as it is received.
If the data displayed on the screen are unrecognizable, you may have selected the wrong input parameters for your particular receiver, for example, Baud Rate 9600 instead of Baud Rate 4800. Check your receiver manual to be sure that you have selected the proper parameter. If the screen is blank, you may have a broken connection, and no data is being received or you may have connected the device to the other input port.
Use [ZOOM IN] to stop (or continue after pause) data displaying, [ENT] to show data in hex or ASCII mode (normal or small) and [CLR] to exit.
Loop-Back Test
This is a special test done during the production phase to check the serial ports integrity. A special connector is required.
Page 132 |
| CPF180i and CPF300i |
|