Standard Horizon CPF180I, CPF300I owner manual Battery Connections, Nmea Connections

2.4.3.2 Connection a VideoCamera, AIS receiver, VHF and Autopilot

Optional WAAS GPS

VIDEO antenna

Camera

CPF300i

Transducer

Red

Black

		2A
		Fuse
Blue	Port 1	Input
Brown	Port 1	Output
Gray	Port 2	Input
Yellow	Port 3	Output
PWR & ACC 1 Cable

Switch

- +

Battery

10-35Vdc

VHF

AIS

PILOT

NOTE

The Input and Output baud rate for each port is set using the Advanced Setup>In/Out Connections menu. For example if Port 1 is set for AIS 38400, the Input and Output both operate at 38400 baud.

AIS Setup

The CPF300i has to be setup to be able to receive NMEA information from the AIS receiver.

1.Press [Menu], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].

2.Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move the ShuttlePoint knob to the right.

3.Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT] or move the ShuttlePoint knob to the right.

4.Move the ShuttlePoint knob to highlight PORT 2 INPUT and press [ENT] or move the ShuttlePoint knob to the right.

5.Move the ShuttlePoint knob up/down to select AIS 38400 and press [ENT] or move the ShuttlePoint knob to the right.

2.5BATTERY CONNECTIONS

1.The GPS Chart Plotters are supplied with a fuse and holder. This fuse should be installed into the Black wire to protect the NMEA Output/Input circuits from becoming damaged.

2.Connect the Red and Black wires from the GPS Chart Plotter to a 12VDC source directly as possible.

2.6NMEA CONNECTIONS

The GPS Chart Plotter can be connected to external devices with NMEA and display information, examples:

·DSC VHF Radio

·Depth Sounder, Speed Log, Wind Instrument, Autopilot etc.

·Radar (USA only)

·Personal Computer

Page 24 CPF180i and CPF300i