![](/images/new-backgrounds/1247215/24721559x1.webp)
mode. Now as the ship moves through the water the vessels position will be kept in the center of the display.
NOTE
To change from Cursor mode to Home mode press [CLR].
3.1.2Cursor and Menu selection speed
The CPF180i and CPF300i allow you to control the speed the Cursor moves when the ShuttlePoint knob is pressed. To change the speed:
Figure 3.1.2 - Cursor Speed menu
1.Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2.Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move the ShuttlePoint knob to the right.
3.Move the ShuttlePoint knob to highlight CURSOR SPEED and press [ENT] or move the ShuttlePoint knob to the right.
4.The menu now shows two selections, CHART and MENU which allows the Cursor Speed to be selected to High, Medium or Low on Chart page or within the menus.
5.With CHART or MENU selected, press [ENT] or move the ShuttlePoint knob to the right. Move the ShuttlePoint knob to the desired setting and press [ENT] or move the ShuttlePoint knob to the right.
6.Press [CLR] until the menu disappears or an easier method is to press the ShuttlePoint knob to the left a few times.
7.Move the cursor on the Chart page and see if the speed is to your liking.
3.1.3Changing the Ships Icon
The cursor may be changed to any of the following:
Figure 3.1.3 - Ship icons
1.Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2.Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move the ShuttlePoint knob to the right.
Page 32 |
| CPF180i and CPF300i |
|