Standard Horizon Ff520 installation and operation guide Introduction, General Information

1. INTRODUCTION

This chapter provides basic information in becoming familiar with the advanced functions of the FF520 before you start using it combined with the STANDARD HORIZON GPS Chart Plotters.

1.0GENERAL INFORMATION

The STANDARD HORIZON GPS Chart Plotters combined with the sonar performance of the FF520 creates the most advanced marine navigation system available. This Owner's Manual covers the Fish Finder functions of the FF520 when used with the STANDARD HORIZON GPS Chart Plotters.

The FF520 advanced features include:

·A-Scope (displays Sonar Echo in real time)

·Preset modes (Fish, Cruise)

·2x and 4x Zoom (capability to magnify any part of the Fish Finder image of a fixed rate)

·Bottom Lock (capability to magnify a user defined range around the bottom)

·White Line (help distinguish between fish and bottom, when fish are swimming close to the bottom)

·Sensitivity Time Control (STC) reduces Surface Clutter shown on the display by reducing echoes from water disturbances

·Surface Noise Filter (suppresses the displaying of Surface Clutter)

·Interference Rejection (allows reducing interference from other boats/Fish Finders)

·Noise Filter

·Fish Symbol feature

·Transducer ID (automatically selects power output and parameters for best performance).

·Dual Frequency: 50 and 200kHz with the capability to display the two frequencies at the same time.

·Dual Power output: 500/1000W (4000/8000Wpp) depending on the transducer con- nected. Refer to Par. 3.0.7 "Optional Transducers ID Sensors".

·Max Depth*: 1KW - 1200Ft (365m) at 200kHz, 4000Ft (1219m) at 50kHz

500W - 700Ft (213m) at 200kHz, 1500Ft (457m) at 50kHz

·Min Depth: 2.5Ft (0.8m) at 200kHz, 5Ft (1.6m) at 50kHz

·Max Typical*: 1KW - 980Ft (299m) at 200kHz, 2700Ft (823m) at 50kHz 500W - 600 Ft (183m) at 200kHz, 1350Ft (411m) at 50kHz

NOTE*

This is not a guaranteed specification. The actual maximum depth capability of the system depends on the type of transducer fitted, the reflectivity of the bottom, water condition, etc.

·Speed Sensor (if available on transducer)

·Dual temperature inputs Sensor (One channel TEMP1, Optional second channel TEMP2) - if available on transducer

·Trip Log

·External buzzer connections (buzzer not supplied)

·Alarms - Shallow, Depth, Temp Upper, Temp Lower

NOTE

Transducer ID is only available with STANDARD HORIZON DST520, DST521, DST523, DST525, DST526, DST527 and DST528 transducers.

FF520 Page 7