This procedure feeds fanfold paper to a position where it can be torn off easily.

24Control Panel Operations

Setting the top of form position

The current position of paper loaded in the printer is automatically set as the top of the page whenever you turn power on. You can also use the following procedure at any time to specify a different position as the top of the page.

Make sure the printer is off-line (ON LINE indicator is not lit).

Use the micro feed operations (see above) to move the paper so that the print head is located where you want the new top of form position to be.

While holding down FONT, press SET/EJECT/PARK.

The printer will beep once to indicate that a new top of form position has been set.

Tear-off function (fanfold paper)

Check to make sure that the printer is on-line.

Press the FORM FEED button to perform the long tear-off operation, or press the LINE FEED button to perform the short tear-off operation.

The long tear-off operation causes the paper to be fed automatically so the tear assist edge of the printer cover is aligned with the paper’s next perforation.

The short tear-off operation causes the paper to be fed automatically so the tear assist edge of the printer cover is located just below the last line printed on the paper.

Pull the paper against the tear assist edge to tear it off.

When you resume printing, the printer reverse feeds the paper to its former position.

Selecting the Quiet Print Mode

The Quiet Print Mode lets you print with less noise than that produced with normal printing. Use the following procedure to enter and exit the Quiet Print Mode.

Important!

Though the Quiet Print Mode prints more quietly, it also causes printing to take considerably longer than normal printing.

Page 30
Image 30
Star Micronics LC-1021 Setting the top of form position, Tear-off function fanfold paper, Selecting the Quiet Print Mode