Star Micronics LC-1021 user manual Adjusting the dot alignment, DOT Adjustment Setting Draft

Repeat the above steps for each printing mode, if necessary.

Press SET/EJECT/PARK to change to another printing mode.

❏

❏

❏ After making changes to adjustments in all the printing modes you want, press ON LINE to exit the Dot Adjustment Mode and register your adjustments.

The above step performs alignment for the Draft printing mode only. You must make separate adjustments for the HS-DRAFT,D-Density/Speed, D- Density P-Graph, NLQ, Quadruple Density, Normal Density, Plotter Graphics, CRT Graphics I, CRT Graphics II, and Double Density modes as well.

Adjusting the dot alignment 51

Adjusting the dot alignment

You may never have to use the procedure described in this section, but after you have been using your printer for some time you may find that the dots of some graphics do not align correctly. For example, what should look like:

may come out looking like one of the following:

or like this

This is caused when mechanical parts of the printer get out of alignment. This happens only rarely and you may never experience it at all throughout the life of the printer. If you do have problems, use the following procedure to correct it.

❏Make sure that paper is loaded in the printer.

❏Turn off the printer.

❏While holding down the control panel’s FORM FEED and ON LINE buttons, turn the printer back on to enter the Dot Adjustment Mode.

The printer will print something like the following.

*** DOT ADJUSTMENT SETTING ***

DRAFT 0:

Note that the printer will feed the paper forward and back each time during this operation so you can view the printout.

❏If the three lines do not align properly, use FONT to move the middle line to the left or PITCH to move it to the right.