Star Trac E-STi, E-TBTi, E-RBi, E-UBi Installing Your Pvs On The E-Ub, E-Rb, E-Tbt, And E-St, Step

INSTALLING YOUR PVS ON THE E-UB, E-RB, E-TBT, AND E-ST

The Star Trac Personal Viewing Screen is different for each of your Star Trac E-Series Cardio prod- ucts. Make sure you have the proper kit for the E-Series product you are installing. The E-UBi, E- RBi, E-TBTi, and the E-STi will follow the same basic steps for installation. For the E-TRi turn to ap- propriate section of this manual.

STEP 1.

Using a #2 Phillips screwdriver, remove the (8) screws on the back of the display plastic. Set the screws aside, you will need them for re- assembly.

STEP 2.

After the screws have been removed, carefully open the display plastic, so as to not detach the inner cables from the display.

Disconnect the ground wire 1 between the heart rate board and the display mount.

STEP 3.

Disconnect the 12-pin serial cable 2 and the

heart rate cable 3 from the display.

After all the cable/harnessing has been disconnected, place the front display plastics aside for later use. Be careful with the display and place it face down on top of a non-scratching surface.

10 620-7991 Rev 002