Star Trac E-RBi, E-STi, E-TBTi, E-UBi, E-TRi manual Step, Plug in the 2 DC power cables to

STEP 11.

While holding the new center console near the opening of the display, connect the following cables to there appropriate connector. (There is no particular order):

•	Plug in the (2) DC power cables to 1		the DC connectors, (they are the same so it does not
	matter which goes to which).
•	Plug in the PVS remote cable to the	2	PVS remote connector.

• Plug in the A/V cable to the audio (6-pin) and the video (2-pin) connector, respectively, to the 3

A/V connectors on the center console board.

• Take the 4 keypad tail, and the 5 center console ground and feed them through the cable

window.

STEP 12.

Close the center console. Using a #2 Phillips screwdriver, take the screws retained from earlier and screw in the (4) screws from below that hold in the center console. Tighten the screws snug.

22 620-7991 Rev 002