Star Trac E-UBi, E-STi, E-TBTi, E-RBi, E-TRi manual Step

STEP 24.

Using a #2 Phillips screwdriver, secure the front display to the back with the (8) screws you pre- viously removed and saved.

STEP 25.

Now with the Personal Viewing Screen installed on your Star Trac equipment, it is time to con- nect your entertainment cable and power to the unit. Look at the bottom of the neck, next to the floor. Connect your in-house Entertainment ca- ble to the RF input. Take the power supply from the PVS kit and plug the small barrel connector to the DC input. Now take the appropriate power adapter cable from the kit and plug it into the power supply and the electrical receptacle.

Only use the power supply that was provided in your Personal Viewing Screen Kit. Us- ing the wrong supply may damage your PVS.

This completes the installation of the Personal Viewing Screen on the E-UB / E-RB / E-TBT / E-ST.

Now it is time to set it up. Turn to the appropriate section for your Personal Viewing Screen.

18 620-7991 Rev 002