Star Trac E-UBi, E-STi, E-TBTi, E-RBi, E-TRi manual Step, Caution Do not over tighten screws

STEP 13.

•Plug the center console’s ground ca- 1 ble into the quick disconnect tab on the back display mount.

•Connect the keypad tail to the 2 k e y - pad connector on the display board.

• Connect the interface cable to the 3 In-

terface connector J11 on the display board.

STEP 14.

Go to the base of the treadmill neck. Using a #2 Phillips screwdriver, remove the (2) screws that hold in the RF cable Mounting Bracket. Retain the screws for later use.

STEP 15.

Remove the nut and washer from the F-Type connector on the end of the coax cable you fed down the treadmill neck, then put connector through the mounting bracket. Replace the nut and washer, and tighten the nut snugly.

Next replace mounting bracket into the neck, using the screws retained from previous step. Tighten with a #2 Phillips screwdriver.

STEP 16.

Replace the bottom back plastic cover. Using a #2 Phillips screwdriver insert the (6) screws, re- tained from earlier step, into the plastic and tighten snug.

Caution: Do not over tighten screws.

23 620-7991 Rev 002