Star Trac E-RBi, E-STi, E-TBTi, E-UBi, E-TRi manual Step, Retain screws for later use

STEP 7.

Mount the PVS assembly on the mounting bracket, then thread the (4) M8 buttonhead screws through the PVS mounting bracket into the display mount. Do not tighten the screws yet.

Note:

(2)of the screws are in the PVS kit, (2) retained from step 5.

STEP 8.

Adjust the cap with the grommet into place. Using the 5mm Hex key, tighten the M8 buttonhead screws to 190 lb-in (21.5 N-m) of torque. Take the (2) Phillips head screws you removed from the original cap and snugly tighten screws down using a #2 Phillips screwdriver.

Check the back side of the display to see that the cap is seated properly. If not, loosen the two Phillips Head Screws, adjust the cap and then retighten the screws.

STEP 9.

Using a #2 Phillips head screwdriver, remove the (4) screws that hold bottom side of the dis- play console on. Next remove the bottom cover. Caution: When removing bottom cover, gently disconnect the CSAFE cable from the back of the display board.

Retain screws for later use.

12 620-7991 Rev 002