Star Trac E-TRi, E-STi Step, Make sure pin one on the cable is connected to pin one on the board

STEP 13.

Note: If the iPod cable comes pre-installed on the cradle, skip this step.

Take the iPod® cable from the kit. Install the cable into the iPod® cradle on the front side of the display console by removing the plug from the cradle then inserting the cable through open- ing. Make sure cable is aligned properly with the display plastics. Press firmly to ensure the cable is seated into the cradle.

STEP 14.

With the center console now installed, it is time to attach the USB cable, center console ribbon and the iPod® cable. Take the USB cable from the center console and attach it to the CCB J14 connector on the display board. Next take the center console ribbon cable and attach it to the display PC board. Then take the iPod® cable from the base of the mount to the center con- sole. Tie the iPod® cable to the plastic using the 3.5” tie wrap.

Make sure pin one on the cable is connected to pin one on the board.

STEP 15.

Next replace the bottom cover. Using a #2 Phil- lips head screwdriver, replace the (4) screws that hold the bottom side of the display console on. Then plug in the CSAFE cable to the back of the display board.

14 620-7991 Rev 002