Star Trac E-STi, E-TBTi, E-RBi, E-UBi, E-TRi manual Step

With the changes now completed on the display, it is now time to re-install the display console to the base unit. There are the (3) cables from the PVS mount that will need to be attached to the display. One cable from the PVS mount will be fed through the display which will be connected to the head phone jack later. The fifth cable from the PVS mount, which is the coax, will be connected to the coax on the base unit. There are (2) cables from the base unit that will be connected to the display. Use the image below to help reference the needed points on the display.

STEP 16.

Take the coax cable from the PVS mount and attach it to the coax cable on the base unit. Tighten the connectors snug to each other.

STEP 17.

Now take the 5” silicon wrap from the kit and peel off its protective tape then wrap the two connectors so that all of the metal surface is covered

STEP 18.

Using a 5” tie wrap from the PVS kit, bind the cables from the PVS neck to one side of the display mount. Take the tie and put it through the hole on one of the display mount tubes.

STEP 19.

Now, take the front display plastics with the new center console to the base unit. Hold the front display plastics at the top with one hand while connecting the cables/harnesses with the other. There is no particular order in connecting the cables. However, it may be best to start off con- necting the cables/harnessing coming from the neck of the base unit.

15 620-7991 Rev 002