Figure 8: Removing the Screw Knob
4-4-2 Checking Rotation Direction
Check the correct direction of the rotor as follows:
1.Turn the main disconnect switch to “ON”.
2.Pull the Start button until the motor comes up to speed; then push the button to stop the granulator motor.
3.Check via the appropriate window that the rotor direction corresponds to that shown on the arrow label that is located above the guard.
If the rotation direction is correct, the granulator is ready to use. If the rotation direction is incorrect, reverse the rotor direction as follows:
!!Warning!!
A LICENSED ELECTRICIAN must carry out this operation.
1.Disconnect and lockout the power to the machine at the incoming power source. If the disconnect is not lockable, remove the fuses.
2.Reverse any two of the three power line conductors to the machine. If there is more than one motor on the machine and only one is turning in the wrong direction, reverse any two of the three line conductors at the overload relay for that motor.
3.Unlock the power and switch the electrical disconnect switch to “ON”. (Replace the fuses if necessary.)
4.
Page 26 of 54
