SSE 5 BL
If a disturbance occurs in the unit, an alarm message will be issued (option, only if the alarm indicating device has been activated).
&An “E” appears in the display and an error number. The alarm indicating device (signal siren, horn) reacts.
FThe control system can only restart operation when the malfunction has been corrected.
Press the “acknowledgement key”.
&The cause of the malfunction will not be corrected by pressing the “acknowledgement key”.
The following error messages can be displayed:
“E1"
The alarm message “E1" is displayed when no material has been conveyed during 3 consecutive conveying cycles.
Check that sufficient material is being conveyed. Check that the flap switch is set correctly.
FWhen the malfunction has been corrected press the key.
“E2"
If the control system becomes too hot during operation (>70°C, 158°F) the “E2" alarm message is displayed and the unit is switched off.
Ensure that the control system is sufficient cooled.
Error and error correction 7
