Sterling Plumbing 6103 Series manual Secure the Bath, Nail, Secure the Apron, For clip attachment

(1) Nail	Attachment Clip	Bath
Clou	Clip d'attache
Clavo	Clip de sujeción	Baignoire
Stud		Bañera
Montant

Poste de madera

Normal Pocket Attachment Attache normale de poche Fijación a un encajonado de postes tamaño normal

Oversized Pocket Attachment Attache surdimensionnée de poche Fijación a un encajonado de postes tamaño grande

Bath Flange

Bride de la baignoire

Reborde de la bañera

Apron Flanges Brides de bandeau Rebordes del faldón

(2)

Roofing Nail

Clou pour toiture

Clavo de techar

Wall Stud

Montant mural

Poste de la pared

Secure the Bath

Secure the Apron

Drill two 1/16″ (2 mm) pilot holes through each apron flange and into a stud. Fasten the flanges to the stud using roofing nails or non-tapered flathead screws.

NOTE: If the apron flanges have broken off from the apron, ensure that the apron is held in place by the wooden blocks (previously installed). If a baseboard will be installed at the apron, drill pilot holes and fasten the apron to the wooden blocks.

Attach the Bath to the Studs

NOTE: The bath can be attached using the clips (provided), roofing nails, or non-tapered flathead screws. Ensure the roofing nails or non-tapered flathead screws are galvanized or plated.

Verify the studs are within 1/8″ (3 mm) of the bath at the recommended clip or roofing nail locations. Shim if necessary.

For clip attachment (1):

Refer to the ″Roughing-In″ section for recommended clip locations.

At the side of the stud, position the bottom lip of the clip under the flange of the bath, as shown.

Slide the clip into place between the center of the stud and the bath. Use a pliers to bend the tab of the clip over the bath flange.

Repeat these steps for the remaining clips.

Secure the clips to the studs with roofing nails or non-tapered flathead screws. Use caution to avoid hitting the bath with a hammer.

1064907-2-A 20 Sterling