
|
| Disengaging the chain brake. | ||
Mounting the Bar and Chain |
| |||
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
| English |
3 | 1 | 1 |
Removing the chain sprocket cover
143BA034 KN |
NUnscrew the nuts and take off the chain sprocket cover.
001BA186 KN
NPull the hand guarad towards the front handle until there is an audible click – the chain brake is disengaged.
Fitting the chain
2 4 | KN |
| 001BA187 |
NFit the guide bar over the studs (1) – the cutting edges on the top of the bar must point to the right.
NEngage the peg of the tensioner slide in the locating hole (2)
N Turn the tensioning |
screw (4)clockwise until there is |
| 1 |
2 | KN |
| 001BA185 |
NTurn the screw (1) counterclockwise until the tensioner slide (2) butts against the left end of the housing slot.
143BA003 KN
WARNING
Wear work gloves to protect your hands from the sharp cutters.
NFit the chain – start at the bar nose.
very little chain sag on the |
underside of the bar – and the drive |
link tangs are engaged in the bar |
groove. |
NRefit the sprocket cover and screw on the nuts only fingertight.
NGo to chapter on "Tensioning the Saw Chain"
MS 660 | 27 |