Stoelting 4231G, 4231H INITIAL SET-UPAND OPERATION, 3.1OPERATOR’S SAFETY PRECAUTIONS, 3.2OPERATING CONTROLS AND INDICATORS, SECTION, OFF, Know the freezer, Figure 9. Controls

SECTION 3

INITIAL SET-UP AND OPERATION

3.1OPERATOR’S SAFETY PRECAUTIONS

SAFE OPERATION IS NO ACCIDENT; Observe these rules:

A. Know the freezer. Read and understand the Operating Instructions.

F.Disconnect electrical cord for maintenance. Never attempt to repair or perform maintenance on the freezer until the main electrical power has been disconnected.

G.Do not operate under unsafe operating conditions. Never operate the freezer if unusual or excessive noise or vibration occurs.

B.Notice all warning labels on the freezer.

C.Wear proper clothing. Avoid loose fitting garments, and remove watches, rings or jewelry, which could cause a serious accident.

D.Maintain a clean work area. Avoid accidents by cleaning up the area and keeping it clean.

E.Stay alert at all times. Know which switch, push button or control you are about to use and what effect it is going to have.

3.2OPERATING CONTROLS AND INDICATORS

Before operating the freezer, it is requires the operator know the function of each operating control. Refer to Figure 9 for the location of the operating controls on the freezer.

WARNING

THE OFF-SERVE SWITCH MUST BE PLACED IN THE OFF POSITION WHEN DISASSEMBLING FOR CLEANING OR SERVICING. THE FREEZER MUST BE DISCONNECTED FROM ELECTRICAL SUPPLY BEFORE REMOVING ANY ACCESS PANEL.

Spigot Switch (behind panel) Activated by Spigot Handles

Clean-Off-Serve Rocker Switch

Red Light (Push to Freeze) Green Light (Ready to Serve)

Low Mix Light

Front Door Interlock Switch Actuator (located between barrels behind stainless steel panel)

Ë Ë

ÆÊ

ËDispense Rate Adjusters

ËClean-Off-Serve Rocker Switch

ÅRed Light (Push to Freeze) Green Light (Ready to Serve)

ÉLow Mix Light

High Pressure Reset Button (under lower front panel) Water Cooled Only