E.Remove the auger assemblies from the freezer. Pull the augers out of the freezer barrel slowly. As the augers are being pulled out, carefully remove each of the plastic flights with springs (Fig. 24).

Figure 21. Removing Front Door

C.Remove rosette cap. Push the spigot body through the bottom of the front door and remove the spigot body (Fig. 22).

Figure 22. Removing Spigot

D.Remove the front auger supports and bearings (Fig. 23).

Figure 23. Removing Auger Supports
Figure 24. Auger Shafts

F.Keep the rear of the auger shafts tipped up once they are clear of the freezer barrels to avoid dropping rear seals.

G.Remove the rear seals.

H.Wipe socket lubricant from the drive end (rear) of the auger with a cloth or paper towel.

I.Remove all “O” Rings from parts by first wiping off the lubricant using a clean paper towel. Then squeeze the “O” Ring upward with a dry cloth. When a loop is formed, roll out of the “O” Ring groove (Fig. 25).

Figure 25. Removing O-Ring

WARNING

DO NOT USE ANY TYPE OF SHARP OBJECT TO REMOVE THE “O” RINGS.

13