Figure 27. Exploded View of Auger

CAUTION

DO NOT PLACE THE MIX INLET REGULATOR INTO THE HOPPER BEFORE INSTALLING THE AUGER.

E.Install the two plastic flights onto rear of the auger and insert part way into freezer barrel.

F.Install the remaining plastic flights, push the auger into the freezer barrel and rotate slowly until the auger engages the drive shaft.

G.Install the auger support and bearing into the front of the augers with one leg of the support at 9 o’clock.

NOTE

Apply a small amount of Petro-Gel to the surface of the cam on the spigot handle prior to assembly of handle to the spigot body.

H.Install the spigot bodies with ”O” Rings into the front door from the bottom (Fig. 28). Push straight up until the spigots are in place. Install rosette cap.

I.Install the front door on the freezer.

J.Install the circular knobs on the freezer studs.

Figure 28. Exploded View of Front Door

CAUTION

FINGER TIGHTEN THE CIRCULAR KNOBS EVENLY. DO NOT OVERTIGHTEN KNOBS.

Look for the proper seal between the freezer barrel, “O” Ring, and front doors.

K.Install the mix inlet regulators into the hopper with the air inlet (long) tube toward the front of the freezer (Fig. 29).

15