INSTALLATION INSTRUCTIONS
INSTALLATION
3.3Remove the lower front panel by gripping the top tag and pulling gently upwards and out. Locate the two bolts securing the appliance to the crate base and remove. See diagram 3.
3
AR1290/1
3.4Gently remove the appliance from the crate and place into its intended position. Locate the two securing holes in the base subframe (those previously used to secure the appliance to the crate), mark the positions on the floor and place the appliance to one side. See diagram 4
4
AR1292
3.5Drill the two holes and insert the rawl plugs supplied. If the gas supply is to enter through the floor under the appliance, now is the time to make the necessary provision for the gas supply.
3.6Place the appliance back into position, level the appliance if required by adjusting the 3 levelling screws and then secure in place using the screws supplied. See diagram 5.
5
AR01292
3.7It will now be necessary to decide upon the flue route and make the necessary flue connections. Two types of flue termination are available, a horizontal terminal discharging on a vertical wall or a vertical terminal discharging above the roof level. Refer to Section 2 in Site Requirements for allowable flue configurations in each instance.
3.8When the flue configuration and lengths are known, it may be necessary to fit a flue restrictor. Refer to Technical Specification on page 8 for the correct restrictor size. This should be fitted by removing the internal and external spigots. The restrictor should be located between the underside of the inner spigot and the air duct. Refer to diagram 6.
6
13
