Stovax P8627 BS manual Installation Instructions, Fitting The Door, AR1198, AR1199, AR1120, AR1295

INSTALLATION INSTRUCTIONS

INSTALLATION

8

AR1198

4.7Place log G at the front of the fire between logs D and E.

DO NOT PLACE THIS LOG ON THE BURNER. IT IS ONLY TO FILL THE GAP BETWEEN LOGS D AND E. The charred effect should face the rear of the fire. See diagram 9.

9

AR1199

4.8With the granules fill the front compartment around the logs evenly. ENSURE NO GRANULES FALL ON THE BURNER. See diagram 10.

10

AR1120

NOTE: ENSURE THAT THE LOGS ARE POSITIONED AS ABOVE. ONLY USE THE CORRECT AMOUNT OF LOGS AS SPECIFIED IN THE DIAGRAMS.

5.FITTING THE DOOR

5.1Ensure that the fibreglass seal on the back of the glass frame is intact then hook the location tabs over the hooks on the top of the firebox. Replace the nine screws working from the top down. Tighten the screws evenly. DO NOT OVER TIGHTEN. See diagram 11.

NEVER OPERATE THE APPLIANCE WHEN THE GLASS PANEL IS REMOVED OR BROKEN.

5.2Close the front door of the appliance by pushing centrally on the RH side, the door catch should locate in the closing mechanism and finish in the closed position.

5.3It may be necessary to re-adjust the door closing mechanism due to vibration whilst in transit. Vertical adjustment should be made by loosening the two nuts directly above and below the locking mechanism on the RH internal side of the outer body. See diagram 11.

11

AR1295

5.4Horizontal adjustment should be made by loosening the two bolts, which hold the locking catch to the rear of the door. See diagram 22.

22

AR1296

17