USER INSTRUCTIONS
5. CLEANING THE NEMOS
ENSURE THE APPLIANCE IS COLD BEFORE PROCEEDING.
5.1The outside casing of the Nemos should be cleaned using a damp cloth. If you have a stainless steel door version, it should be cleaned using a stainless steel cleaner.
5.2To clean the burner system, firstly depress the front door centrally on the RH side and the door will release allowing you to open fully. See diagram 1.
1
AR1287
5.3Remove the glass panel by unscrewing the nine pozidriv screws. See diagram 2.
2
AR0816
5.4Remove the ceramic logs and place on a dry, clean surface. It is not essential to remove the embers.
5.5The logs should not require cleaning. Do not use a vacuum cleaner or brush to clean the logs, any large pieces of debris may be removed by hand.
5.6Ensure any debris is removed from the burner ports.
5.7Replace the ceramics and door by referring to section 6.
5.8To clean the glass surface, Gazco recommends you use a ceramic glass product generally sold for cleaning ceramic hobs.
6.ARRANGEMENT OF FUEL BED COMPONENTS
ADVICE ON HANDLING AND DISPOSAL OF FIRE CERAMICS
The fuel effect and side panels in this appliance are made from Refractory Ceramic Fibre (RCF), a material which is commonly used for this application.
Protective clothing is not required when handling these articles, but we recommend you follow normal hygiene rules of not smoking, eating or drinking in the work area and always wash your hands before eating or drinking.
To ensure that the release of RCF fibres are kept to a minimum, during installation and servicing a HEPA filtered vacuum is recommended to remove any dust accumulated in and around the appliance before and after working on it. When servicing the appliance it is recommended that the replaced items are not broken up, but are sealed within heavy duty polythene bags and labelled as RCF waste.
RCF waste is classed as stable,
Excessive exposure to these materials may cause temporary irritation to eyes, skin and respiratory tract; wash hands thoroughly after handling the material.
6.1Place log A on to the burner. Ensure the rear of the log touches the rear of the burner. See diagram 3.
3
AR0816
CENTRALISE THE LOG BETWEEN THE BURNERPORTS AT EITHER END
Four of the remaining logs have location holes on the underside. These locate on the studs at the front of the fire.
6.2Place log D on the third stud from the left and resting at the rear of log A. See diagram 4.
5
