USER INSTRUCTIONS
1.general
1.1A competent person must carry out installation and servicing.
1.2In all correspondence, please quote the appliance type and serial number, which can be found on the databadge located on a plate under the control valve.
1.3Ensure that curtains are not positioned above the appliance and there is at least 300mm between the sides of the appliance and any curtains.
1.4If any cracks appear in the glass panel do not use the appliance until the panel has been replaced.
1.5If, for any reason, the flue has to be removed from the appliance, the seals must be replaced in the inner spigot.
1.6Do not obstruct the flue terminal in any way, i.e. by planting flowers, trees, shrubs etc in the near vicinity, or by leaning objects up against the terminal guard.
1.7Do not use a garden sprinkler or hose near the terminal.
1.8Do not stand or place objects on the terminal guard as this will deform it.
This product is guaranteed for 2 years from the date of installation, as set out in the terms and conditions of sale between Gazco and your local Gazco dealer. Please consult with your local Gazco dealer if you have any questions. In all correspondence always quote the Model Number and Serial Number.
2.lighting the NEMOS
2.1Locate the control valve on the appliance. There are two control knobs on the valve, the right hand knob controls the pilot ignition and the left hand knob controls the main burner.
2.2If your appliance has already been upgraded to battery remote control, please refer to the instructions provided with the upgrade to operate the remote control. The following instructions will work for either situation.
2.3Ensure that the left hand control knob is pointing to off (
).
2.4Ensure that the right hand control knob is pointing to off (
).
2.5Press in the right hand control knob and rotate it anti- clockwise until a click is heard (keep pressing in) and the knob is pointing to pilot (
). The pilot should now light. If the pilot has not lit, repeat the procedure until it does.
2.6Keep the control knob pressed for 10 seconds and then release it, the pilot should stay alight. If the pilot goes out, repeat the procedures until it does.
2.7If the pilot will not light after repeated attempts, contact the retailer or installer from whom the appliance was purchased.
2.8Turn the right hand control to point to main burner (
). The appliance can now be controlled using the left hand control knob.
2.9Turn the left hand control knob to point to low fire (
),
the main burner will light on low. The burner can now be controlled between low and high settings. Turn the control knob anticlockwise to increase the flame height and clockwise to decrease the flame height.
THE YELLOW FLAMES WILL APPEAR WHEN THE FIRE HAS GAINED SUFFICIENT HEAT - TYPICALLY 10 TO 20 MINUTES.
3.turning the NEMOS off
3.1To turn the Riva off, locate the control valve, turn the left hand control knob until it points to off (
). The main burner will go out leaving the pilot burning.
3.2To turn the pilot off, locate the control valve, turn the right hand control knob until it points to off (
), the pilot will go out.
IF THE FIRE IS EXTINGUISHED OR GOES OUT IN USE, WAIT 3 MINUTES BEFORE ATTEMPTING TO RELIGHT THE FIRE. THE CONTROL VALVE HAS AN INTERLOCK DEVICE AND THEREFORE CANNOT BE LIT UNTIL THE 3 MINUTES HAVE ELAPSED.
4.upgrading your NEMOS
4.1Your Nemos is fitted with a control valve that can easily be upgraded to battery powered remote control. This upgrade can be fitted by anyone capable of simple DIY jobs and requires no special training. There are two versions of this control which can be obtained through your local Gazco stockist.
4.2STANDARD REMOTE CONTROL This remote control can control the gas appliance after the pilot has been lit. It can turn the main burner on and regulate it from low through to high and back again. It can turn the main burner off leaving the pilot burning. GAZCO PART NUMBER 8455.
4.3PROGRAMMABLE THERMOSTATIC AND TIMER REMOTE CONTROL This remote control can control the gas appliance after the pilot has been lit. In ‘MANUAL MODE’ it can be used to turn the main burner on and manually regulate it from low through to high and back again. It can also be used to turn the main burner off leaving the pilot burning. In ‘AUTO MODE’ it will automatically regulate the room temperature to a
4
